HAKO Hamster 800 V Operating Instructions Manual page 53

Maintenance and Service
Changing the folding apron
2. Unhook the Bowden cable which
raises the folding apron (Fig. 22/3).
3. Disassemble the folding apron
(Fig. 22/1) together with its holder:
Unscrew the screw connections
(Fig. 22/2).
4. Unscrew the screw connections
(Fig. 22/2) in the clamping rail and
remove the clamping rail.
5. Change the sealing strip.
6. Assemble the clamping rail.
7. Assemble the folding apron
(Fig. 22/1) together with its holder
and adjust the folding apron
(Fig. 22/1) so that it lies lightly on the
ground.
8. Hook in the Bowden cable which
raises the folding apron (Fig. 22/3).
When closed, the folding apron
must not be drawn in by the
rotary brush!
Changing the side aprons
9. Unscrew the screw connections
(Fig. 22/5) in the side aprons
(Fig. 22/4+8).
10.Change the sealing strips and adjust
the side aprons (Fig. 22/4+8): There
must be approx. 2 mm clearance to
the floor.
11.Screw the screw connections
(Fig. 22/5) back in the side aprons
(Fig. 22/4+8). Also screw the ground
of the wing nut at Position A
(Fig. 22/A).
Changing the rear aprons
12.Remove the dirt hoppers, refer to
Section 5.9.1.
13.Unscrew the screw connections
(Fig. 22/7) in the rear aprons
(Fig. 23/1+2).
14.Change the sealing strip and adjust
the rear apron (Fig. 22/6): The
clearance of the rear apron
(Fig. 23/2) from the ground must be
2 mm.
15.Screw the screw connections
(Fig. 22/7) back in the rear aprons
(Fig. 23/1+2).
1
Fig. 23
1 Front rear apron
2 Back rear apron
2
53