Function Faults; Options - HAKO Hamster 800 V Operating Instructions Manual

Operation
• Secure the machine at the front with
a strap which must be fed through
the two openings (Fig. 13/1) near the
front wheel (Fig. 13/2).
• At the rear, thread a strap around the
bottom ends of the handlebar and fix
the strap to the transporter.
1
2
Fig. 13
30
3.4

Function faults

• If the machine is overloaded, the
engine speed drops.
Set the key switch to Position 0.
Check the side brush, rotary brush
and brush area for residual waste
and remove the waste, if necessary.
Ensure that there is sufficient fuel in
the tank (only Hako Hamster 800 V)
or that the batteries are sufficiently
1
charged (only Hako Hamster 800 E).
Start the machine. If the fault occurs
again, contact a Hako service
center.
If the machine cannot be
switched off, pay attention to
the rotating fan when you
disconnect the cable or pull out
the spark plug connector! Risk
of injury!
3.5

Options

The basic machine can be upgraded by
adding further components. The order
and spare parts numbers for these
components are provided in brackets.
• Carpet kit (6460)
By fitting the carpet kit on the Hako
Hamster 800 E, the machine is
converted for clearing up dry waste
from carpets.
Please refer to the spare parts
catalogue on our internet site
at www.hako.com for
accessories, such as rotary
brushes, side brushes etc.