(Only Hako Hamster 800 V); (Only Hako Hamster 800 E) - HAKO Hamster 800 V Operating Instructions Manual

Starting Up
2.1.2 Refueling the engine

(only Hako Hamster 800 V)

Unscrew the fuel tank cap
(Fig. 7/7) and fill approx. 2.5 l gasoline.
Screw the fuel tank cap back on.
Only refuel the machine when
the engine has cooled down.
Otherwise, any spilled
gasoline can evaporate if it
lands on hot machine parts.
Health hazard through inhaling
vapors!
Refueling must not be carried
out in closed rooms.
Refueling may only be carried
out when the engine is
switched off! Remove the
ignition key.
It is forbidden to smoke or use
fire when refueling or working
on or near components
containing fuel.
Wipe up any spilled fuel!
Wipe up spilled fuel with a cloth
and dispose of the cloth
according to the applicable
environmental laws.
2.1.3 Checking the oil level
(only Hako Hamster 800 V)
Engine oil is filled at the factory. As a
precaution, however, check the oil level
again on site, refer to Section 5.4.1.
2.1.4 Connecting the batteries

(only Hako Hamster 800 E)

Before starting up for the first time,
connect the positive cable of the device
as illustrated in Figure 5 to the positive
pole (Fig. 5/1) of the batteries in the
device.
2.1.5 Initial battery charge
(only Hako Hamster 800 E)
Before starting up the machine for the
first time, the batteries used must be
fully charged by completing the initial
battery charge, refer to Section 5.5.1.
Hako assumes no liability for damage to
the battery resulting from failing to carry
out the initial battery charge properly.
Risk of explosion! When
charging the batteries, there
must be sufficient ventilation in
the charging area.
1
Fig. 5
17