HAKO Hamster 800 V Operating Instructions Manual page 23

Operation
Drive bar (Fig. 8/1)
The drive bar serves to activate and
deactivate the wheel drive. The drive
bar must be pulled up towards the
handlebar with the fingers so that the
wheel drive operates and the machine
moves forward. If the drive bar is
released, the machine stops (safety
circuit).
Handlebar (Fig. 8/2)
The machine is guide/steered via the
handlebar.
Release the drive bar when
turning sharp corners.
The two wing bolts (Fig. 8/4) serve to
adjust the handlebar to an optimal
position for the user.
Operating panel (Fig. 8/3)
Refer to Section 3.2.2.
Charger cable (Fig. 8/5)
The charger cable of the Hako
Hamster 800 E is located in the recess
which also contains the shaking device
lever.
Shaking device lever (Fig. 8/6)
To clean the panel air filter, pull the
shaking device lever out then push
back in again; repeat this several times.
Dirt hopper lock (Fig. 8/8)
To remove the dirt hoppers, move the
locking lever to the right (when facing
the front) and, at the same time pivot
the handlebar forwards. The frame of
the dirt hoppers is lowered as a result
so that the hoppers can be removed
towards the rear. To lock the hoppers,
pull the handlebar to the rear until the
lock audibly engages.
23