Fiber-Optic Gigabit Ethernet Connectors And Cables; Figure 16 Two-Port Fiber-Optic Gigabit Ethernet Nic - Nokia 105s Installation Manual

Figure 16 Two-Port Fiber-Optic Gigabit Ethernet NIC

Fiber-Optic Gigabit Ethernet Connectors and Cables

To connect the two-port Gigabit Ethernet NIC to other network components,
use a multimode, fiber-optic cable with an LC connector for each NIC
interface. The destination end of the cable can be either LC or SC, depending
on the type of connector required for the destination Gigabit Ethernet device.
You can also use a half-duplex LC-to-LC cable to loop back the transmit port
of an interface to the receiver port.
Two LC-to-SC cables are included with two-port fiber-optic Gigabit Ethernet
NICs. You can order additional cables from a cable vendor of your choice.
Nokia 105s Gateway Installation Guide
Two-Port Fiber-Optic Gigabit Ethernet Network Interface Card
Ports
Link LEDs (solid green)
Activity LEDs (blinking yellow)
00206
67