Nokia 105s Installation Manual page 94

7
Troubleshooting
information about how to use the tcpdump command, see the Nokia Network
Voyager Reference Guide.
Under Routing Options in the Routing Configuration section in Network
Voyager, you can also enable several types of trace options for DVMRP.
These traces are logged into
For information about how to access Network Voyager and the related
reference materials, see
Problem No IP connectivity.
Solution Verify that you have IP connectivity; ping various hosts on each
network.
Problem DVMRP is not enabled on the interfaces.
Solution Verify that DVMRP is enabled on the interfaces in use.
Problem Exceeding TTL on clients.
Solution Verify that the client is set up for the proper TTL number. Many
clients are set to receive local traffic only one hop away.
Problems Interfacing to 1483 Devices
Problem Remote and local devices are not configured for the same VC and
VP value.
Solution Set remote and local devices to the same VC and VP values.
Consult your 1483 device documentation.
Problem Remote and local devices are not in the supported VC range of
the NIC.
Solution Use
command:
ipsctl ifphys:logical interface:max_rxlabel
94
/var/tmp/ipsrd.log
"Using Nokia Network Voyager"
to determine the VC range. Enter the following
ipsctl
.
on page 43.
Nokia 105s Gateway Installation Guide