Table of Contents
Advertisement
Ethernet Cables
The Nokia 5i and Nokia 10i use IEEE 802.3 10 BASE-T, 100 Base-TX
shielded twisted-pair, CAT-5 ethernet cables.
To connect Ethernet devices:
After you connect the network interfaces, you can perform the initial gateway
configuration. For information about how to configure the gateway, see
Performing the Initial Gateway Configuration in the Nokia IP VPN
Installation Guide.
Ethernet Cable Pin Assignments
Figure 5
output connector is numbered from left to right, with the copper tabs facing
down and toward you.
Nokia 5i and 10i Installation Guide
Use a straight-through RJ-45 cable to connect to a 10-Mbps or 100-Mbps
hub or switch.
Use a crossover RJ-45 cable to connect directly to a host.
shows the pin assignments for an RJ-45 cable. The RJ-45 cable
Connecting Network Interfaces
33
Advertisement
Table of Contents
