Ethernet Nic Connectors And Cables - Nokia 105s Installation Manual

Ethernet NIC Connectors and Cables

The connectors on the Ethernet NIC are RJ-45 connectors:
Use IEEE 802.3 10BASE-T or 100BASE-TX unshielded twisted-pair,
full-duplex or half-duplex cable.
Caution
Cables that connect to the Ethernet card must be IEEE 802.3
compliant to prevent potential data loss.
You can order appropriate adapter cables separately. You can order additional
cables from a cable vendor of your choice.
Figure 10
connector is numbered from right to left, with the copper tabs facing up and
toward you.
Nokia 105s Gateway Installation Guide
To connect to a 10-Mbps or 100-Mbps hub, use a straight-through RJ-45
cable.
To connect directly to a host, use an RJ-45 crossover cable.
shows the pin assignments for the cable. The RJ-45 cable output
Four-Port 10/100 Mbps Ethernet NICs
61