Before You Start - Nokia 105s Installation Manual

Before You Start

To remove, install, or replace a Nokia NIC, you need the following:
To remove, install, or replace a NIC
1. Use Network Voyager or the CLI to halt the gateway.
Nokia 105s Gateway Installation Guide
A Phillips-head screwdriver
Physical access to the gateway
Access to the gateway by using Nokia Network Voyager or the CLI
Suitable, grounded work surface
Network interface card kit
Note
Because power to the 105s gateway is automatically disconnected
when the chassis tray assembly is opened, you do not need to
manually disconnect the power for this procedure. Any servicing of
the unit, however, should be completed with the chassis tray
assembly fully removed from the gateway. Power is still active in the
chassis body and care should be taken when working on the power
supply or power supply wiring without disconnecting the power cord.
To use Network Voyager to shut the gateway down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to shut the gateway down, enter halt at the prompt.
Removing, Installing, and Replacing NICs
51