Nokia 105s Installation Manual page 34

2
Installing the Nokia 105s Gateway
Note
To use the cable for modem connections from the auxiliary port, you need
to order a modem cable kit. For information about contacting Nokia to
order the kit, see
Note
The cable described in this section is a rollover cable, which is required
for 105s console and auxiliary port connections. You cannot use standard
Ethernet cables for 105s console and auxiliary connections.
To connect the cable, push the connector into the receptacle, as you would
with other similar cables. To disconnect the cable, push the cable toward the
gateway, pull back on the boot to release the latch, and pull the connector out
of the receptacle.
34
"Nokia Contact Information"
To connect the cable
To disconnect the cable
on page 3.
1 + 2 =
2 Pull boot
1
Nokia 105s Gateway Installation Guide
Push cable
00548a