Nokia 105s Installation Manual page 38

2
Installing the Nokia 105s Gateway
To connect copper Gigabit Ethernet devices
Use a straight-through or crossover RJ-45 cable to connect to a 10-Mbps,
100-Mbps, or 1000-Mbps hub or directly to a host.
Note
All Nokia copper Gigabit Ethernet NICs support cable auto-sensing.
You can use a straight-through or crossover cable to connect the NIC
to a Gigabit Ethernet hub or switch, or to connect directly to a host.
For details, see
To connect fiber-optic Gigabit Ethernet devices
Use a multimode, fiber-optic cable with an LC connector to connect to a
10-Mbps, 100-Mbps, or 1000-Mbps hub or directly to a host. The
destination end of the cable can be either LC or SC, depending on the type
of connector required for the destination Gigabit Ethernet device. You can
also use a half-duplex LC-to-LC cable to loop back the transmit port of an
interface to the receiver port.
For details, see
page 67.
After you connect the network interfaces, continue with
"Performing the Initial Configuration."
38
"Copper Gigabit Ethernet Connectors and Cables"
"Fiber-Optic Gigabit Ethernet Connectors and Cables"
Chapter 3,
Nokia 105s Gateway Installation Guide
on page 64.
on