Setting The 802.1X Operational Mode - Avaya one-X 9601 Installation And Maintenance Manual

Shown As
LOG...
LOGOUT
RESET VALUES
RESTART PHONE
SIG...
SIP...
SNTP...
SSON...
VIEW

Setting the 802.1X Operational Mode

!
Important:
The DOT1X configuration parameter must be set to "0" or "1" for the deskphone
Important:
to support 802.1X pass-thru and the DOT1XSTAT configuration parameter must
be set to "1" or "2" for the deskphone to support supplicant operation. For more
information, see the Avaya one-X™ Deskphone SIP Administrator Guide.
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
Note:
the line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to set or change the operational mode.
1. When you select 802.1X from the Craft Local Procedure Screen, the two settings shown
represent the text strings associated with the current configuration parameter values of
DOTIX (802.1X Pass-Thru Mode) and DOT1XSTAT (802.1X Supplicant Mode), defined as
follows:
For the Pass-thru mode:
Craft Procedure Purpose
Enable/disable Event Logging
Log off the deskphone
Reset system initialization
values to defaults
Restart the deskphone
Set the signaling protocol
download flag
Configure SIP call settings
Configure the time server
settings
Set the Site-Specific Option
Number
View current parameter values
and file names
Setting the 802.1X Operational Mode
See
Disable/Enable Event Logging
page 40.
Logout on page 42.
Reset System Values
Restart the Deskphone
Configuring SIP Settings
Configuring SIP Settings
Configuring Time Server Settings
page 46.
Site-Specific Option Number
Setting on page 47.
The View Administrative Option
page 47.
Issue 1 December 2010
on
on page 42.
on page 43.
on page 43.
on page 43.
on
on
31