Disable/Enable Automatic Gain Control - Avaya one-X 9601 Installation And Maintenance Manual

Change the
VLANTEST value
Ping a server (host) to
see if it is reachable/
available
4. Press Save to store the new setting and redisplay the Admin Procedures screen or Cancel
to return to the Admin Procedures screen without saving the value entered. Or, if you sent a
ping to the host server, press OK to return to the Static Address screen.
Once the new values are stored, the deskphone is reset.
If a new boot program is downloaded from the HTTP/HTTPS server after you enter static
addressing information, you must reenter your static addressing information.

Disable/Enable Automatic Gain Control

Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
Note:
the line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to turn automatic gain control for the handset, headset, and/or the
Speaker on or off.
1. When you select AGC from the Admin Procedures Screen, the following text displays:
Handset Auto Gain Control
Headset Auto Gain Control
Speaker Auto Gain Control
where, the setting shown is the text string associated with the current system value of
AGCHAND, AGCHEAD, or AGCSPKR, defined as:
"On" if the respective AGCXXXX system value is "1".
●
Off if the respective AGCXXXX system value is "0".
●
Use the dialpad to enter the new value of the DHCPOFFER wait
period of from 0 to 999, inclusive. Proceed to the next step.
Use the dialpad to enter the IP Address or the DNS Name of the
server you want to check. IP Addresses have three sets of three
digits followed by a period. Pressing * following entry of three
digits causes a period to be placed in the next position, and the
cursor to advance one position to the right.
Press the Ping softkey to initiate the check. The deskphone
sends four pings and displays the results in a text block screen. If
the ping fails, the message "Unable to contact host" displays.
Disable/Enable Automatic Gain Control
On
On
On
Issue 1 December 2010 35