Assembling The Surround – Contura 560T - Contura 510 Installation Instructions Manual

Assembling the surround – Contura 560T
Lay the stove body on its back on the pallet. Secure
the base-plate with four socket-head (female) screws.
Fit them from the inside of the base-frame into the fix-
ing lugs on the base-plate. Do not tighten the screws
until the stove is standing upright on a level surface.
Secure the rear panel by inserting two hexagon
screws at the top and tightening them just 2 or 3
revolutions.
x 3
Loosen the two screws on the rear of the base-frame
by turning them three revolutions anticlockwise.
Then hook the rear panel into place.
Tighten the two screws that hold the bottom of the
rear panel in place.
Clean the glass panels carefully
before fitting the side panels.
Hold the side panel approximately
20 mm above the base-plate and
angle the front edge of the side panel
inwards and around the edge of the
leg.
Hold the side panel in place, and
press it down over the pins that stick
up from the base-plate.
Secure the side panel in place with a
socket-head screw on the top edge
at the front.
111
GB
560T
Important!