Advertisement
Quick Links
Advertisement
Related Manuals for Contura C 780
Summary of Contents for Contura C 780
- Page 1 Installation Instructions C 780 www.contura.eu...
- Page 2 See rating plate on the stove Intended area of use Heating of rooms in residential buildings Fuel Wood MANUFACTURER Name NIBE AB / Contura Address Box 134, Skulptörvägen 10 SE-285 23 Markaryd, Sweden CHECKS According to AVCP System 3 European standard...
-
Page 3: Table Of Contents
A warm welcome to the Contura family. We hope you will get a great deal of pleasure from your new stove. As a new owner of a Contura stove you have secured a product with timeless design and long service life. Contura also has combustion that is both environmentally friendly and efficient for the best heat production. -
Page 4: Technical Details
FACTS Important to remember! Technical details Contura 780 Installation by authorised Structural support technician Check that the wood joists are strong enough to bear the weight of the stove and This manual contains instructions about chimney. The stove and chimney can usually... -
Page 5: Connection To Chimney
CHIMNEY Connection to chimney • The stove meets the requirements for connecting to chimneys • A flue with sharp bends and horizontal routing reduces the dimensioned for 350°C flue gas temperature. draught in the chimney. Maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m. -
Page 6: Supply Of Combustion Air/Option
The amount of air needed for combustion is approximately 25m C 780 The connector has an external diameter of 67 mm. When duct There is a detachable cover... -
Page 7: Installation Distance 780
INSTALLATION DISTANCES Installation distances C 780 The minimum distance in front of WHEN INSTALLING TURNTABLE (OPTION) the following installation distances do not apply. the stove opening to combustible Combustible roof See the separate installation instructions for parts of the building or interior decoration must be at least 1 m. -
Page 8: Installing 780
ASSEMBLY Installing C 780 Remove loose parts before the insert is placed on its back Do not tighten the screws until the Do not tighten the screws before stove has been raised again. the sides and back are installed... - Page 9 ASSEMBLY Clean the side glass thoroughly before installing the side panels.
- Page 10 ASSEMBLY Installing rating plate C 780 The following rating plates must be placed on the inside of the cover on the pillar. Final inspection of the installation It is extremely important that the installation is inspected by an authorised chimney sweep before...
-
Page 11: Removing The Loose Parts
REMOVAL How to remove the hearth surround Handle the vermiculite with care. Lift the smoke baffle with one hand whilst removing the sides. The side posts need not be removed when sweeping. Reinstall in reverse order... - Page 12 NIBE AB · Box 134 · 285 23 Markaryd · Sweden www.contura.eu Contura reserves the right to change dimensions and procedures described in these instructions at any time without 811079 IAV SE-EX C780-10 special notice. The current edition can be downloaded from 2014-01-15 www.contura.eu...