Assembling The Surround – Contura 510/550/550A - Contura 510 Installation Instructions Manual

Assembling the surround – Contura 510/550/550A
Lay the stove body on its back on the pallet. Secure
the base-plate with four socket-head (female) screws.
Fit them from the inside of the base-frame into the fix-
ing lugs on the base-plate. Do not tighten the screws
until the stove is standing upright on a level surface.
Secure the rear panel by inserting two hexagon
screws at the top and tightening them just 2 or 3
revolutions.
Important!
When assembling the 550, clean the glass care-
fully before fitting the side panels.
Hold the side panel approximately 20 mm above the base-plate and angle the front edge of the side panel
inwards and around the edge of the base-frame.
Hook the side panel into place on the rear panel. Hold the side panel in place, and press it down over the pin
that sticks up from the base-plate.
x 3
Loosen the two screws on the rear of the base-frame
by turning them three revolutions anticlockwise.
Then hook the rear panel into place.
Tighten the two screws that hold the bottom of the
rear panel in place.
Important!
To make it easier to fit the side panels, do not
tighten the two top screws holding the rear panel
until the side panels are in place.
105
GB
510/550/550A