Canon imageRUNNER ADVANCE-series Service Manual page 27

3
Operations > Firmware Operations > Downloading and Updating Firmware > c. Manual Download and Update (On-site Update from Service Mode)
7. [Delivery Settings] screen is shown as below. Enter the fields and press [OK] button.
•
[Delivery Time]:
Press either [Now] or [Set Time] button.
•
[Now]:
The firmware is downloaded immediately after distribution schedule is set.
•
[Set Time]:
Be sure to specify the date (within 7 days) and time. The firmware is downloaded on
the specified date and time.
Enter the date and time using the numeric keypad in the format of "yyyy/mm/dd hh:
mm:ss"
•
[Timing to Apply]:
Press either [Auto] or [Manual] button.
•
[Auto]:
The firmware is applied automatically upon firmware downloaded.
•
[Manual]:
The firmware is automatically downloaded. Go to [Apply Firmware] to set up for
updating the downloaded firmware.
•
[Deliver Acquisitions]:
Press either [On] or [Off] button.
•
[On]:
Only difference between the current and new firmware is downloaded.
•
[Off]:
The firmware to be applied is wholly downloaded.
3 Operations > Firmware Operations > Downloading and Updating Firmware > c. Manual Download and Update (On-site Update from Service Mode)
•
[E-mail]:
E-mails concerning update statuses are sent from the device to the contact registered here.
Enter the E-mail address of the service technician in charge.
Enter 1-byte alphanumeric or symbols up to 64 characters.
•
[Comments]:
Enter the comment in 1-byte alphanumeric or symbols up to 128 characters.
Enter the comment to be automatically included in E-mail. Model Name in the comment will
be helpful to identify the device relevant to the E-mail.
NOTE:
[Timing to Apply]
•
For firmware versions with no remote update permission, [Auto] cannot be selected in
[Timing to Apply]
[Deliver Acquisitions]
•
For firmware versions with difference-only delivery disabled, only [OFF] can be selected
F-3-14 F-3-14
in [Deliver Acquisitions].
[E-mail]
•
To send E-mails to multiple destinations, each E-mail address should be delimited with
comma (,) or semi-colon (;).
•
For E-mail addresses entered in this field, a notification E-mail is sent at the following
timing.
-Distribution Set
-Distribution Started
-Distribution Finished
-Update Started
-Update Finished
-Error Occurred
3-7
3-7