Disassemble The Motor; Disassemble The Gear; Disassemble The Latch - SNBC BTP-R880NPI Service Manual

4.2.14 Disassemble the motor

4.2.15 Disassemble the gear

4.2.16 Disassemble the latch

Unscrew the ST2.6*6 screw fixing the paper near end
sensor, take it off from the paper house, and remove
the paper near end holder and the paper near end
bracket from the paper house.
Disassemble the two spring gaskets which fix the
motor and the flat gasket and take off the motor from
the mechanism left holder.
Disassemble the two ∮ 4 "E" rings fixing the gear and
take off the gear from the mechanism left holder.
Fix the latch spring on one end of the mechanism
right holder and unscrew the M3*5 screw fixing the
top cover latch.
- 19 -
BTP-R880NPII Service Manual