SNBC BTP-R880NPI Service Manual page 45

Sensor Test ->4
Cutter Test ->5
Print Statistics ->6
Calibration ->7
Ethernet ->8
Configuration
Set Printer Mode ->10
Enter code,then hold
Button Down
at least 1 second to
validate
Sensor Test Mode:
ERROR LED state will
change
according to sensor state
To EXIT,hold button down
at
least 1 second
BTP-R880NPII
STATISTICS
TCUT :0
TLFS :0
ONTIME :0
Ethernet
CONFIGURATION
Exit Without Save ->1
Exit With Save ->2
Reset Ethernet ->3
Config
Print Settings ->4
Printer Mode: Default
Printer Mode
Back To Last ->1
Menu
Default Printer ->2
Mode
BTP-2002NP ->3
Mode
Saving config, please
wait.
Configurations have
been saved,
please repower the
printer
IP Address:
MAC Address:
SUBNET Mask:
GATEWAY:
Print Port:
- 38 -
BTP-R880NPII Service Manual