Extron electronics AXP 64 C AT Setup Manual page 6

AXP 64 C AT • Setup Guide (Continued)
Click the Device Config tab (
5.
In the Rename Device panel, enter the new name of the device in the text field. No spaces are allowed in the name.
6.
Click Apply. A confirmation prompt opens.
7.
Click Yes to enter the new name, then close the Device Configuration dialog box.
8.
The new name is written to the AXP 64 C AT. Repeat as necessary for all AXP 64 C AT devices.
NOTE:
After the AXP 64 C AT is renamed, it can remain connected to the network. However, subsequent devices must be
connected one at a time and renamed before the next device is connected.
Finding a Dante Device IP Address
To find the IP address of a Dante device, you need the name of the device (see
page).
NOTE:
If the AXP 64 has not been renamed, its default name consists of the product name followed by a hyphen (AXP64-)
plus the last 6 digits of the unit MAC address (for example, AXP64-040C06).
Open Dante Controller for Windows (see
1.
On the Dante Controller main screen, click the Device Info tab (
2.
On the Device Info screen, locate the name of your AXP. The IP address is in the Primary Address column (
3.
Connect the AXP to a computer (using a host communication utility such as Extron DataViewer) or to a control system.
4.
Select a TCP/IP connection and enter the IP address of the AXP 64 where indicated. Enter 4333 for the port number.
5.
6
) to open the device configuration page.
1
Renaming an AXP 64 C
Renaming an AXP 64 C AT
AT).
1 ).
on the previous
).
1