Table of Contents
Advertisement
Quick Tabletop Test
Before installing, it is highly recommended that you carry out a quick test to
familiarise yourself with the equipment and ensure everything is operating
correctly prior to completing the installation. This is best performed in a man-
ageable space close to where you plan to install the Main Unit.
Step 1:
Follow the "Quick Setup Guide" to set up your Main Unit, Door Gap Sensor
and PIRs. In setting up the Main Unit, make sure you connect the telephone
line before connecting the power supply to prevent the unit from beeping.
Step 2:
Complete the "Application for Monitoring Services/Client Information" form
and the "SASG Simple Pay" form online at www.fortknoxsecure.com or mail
a written application to SASG, if you require back-to-base monitoring. The
first 3 months are free of charge and there is no obligation to continue after
the 3 months free period; if you do not wish to continue monitoring after
your free period simply notify SASG online or by mail 1 month before the
expiry of your free 3 months (by completing the bottom section ("SASG
Cancellation" form) of the "Application for Monitoring Services/Client Inform-
ation" form).
Ring the event monitoring Control Room (Australia: 1300 658 813 / New
Zealand 0800 604 570) and advise them that you are about to test your
security system.
If you do not require back-to-base monitoring ignore this step and proceed
directly to the next step.
Zones
Please see the last section "Zones" for a complete explanation of zones.
Zones are a collection of sensors one or more securing a specific location
(e.g., a bedroom).
10
Step 3:
Arm the Main Unit by pressing "ARM" button on the Remote Control. The
Main Unit LCD screen will change its status to "ARM".
Step 4:
Trigger Zone 1 by walking in front of the Zone 1 PIR (labelled on back of PIR).
The red LED will light up when the PIR picks up the movement.
Step 5:
The siren will sound and the Main Unit screen will display 01 & INTRUDER as
it sends the signal to the Monitoring Station. Press "DISARM" button on the
Remote Control to cancel the alarm and the LCD screen will display DISARM
and the siren will stop.
Step 6:
Arm the Main Unit by pressing "ARM" button on the Remote Control. The Main
Unit LCD screen will change its status to ARM.
Step 7:
Trigger Zone 2 by walking in front of the Zone 2 PIR.
The red LED will light up when the PIR picks up the movement.
Step 8:
The siren will sound and the Main Unit screen will display 02 & INTRUDER as it
sends the signal to the Monitoring Station. Press "DISARM" button on the
Remote Control to cancel the alarm and the LCD screen will display DISARM and
the siren will stop.
Step 9:
Press "ARM" button on your second Remote Control and the Main Unit status
will change to ARM on the LCD screen.
Step 10:
Pull the Door Gap Sensor and its Magnet apart. The red LED will light up and
the alarm will be triggered.
11
Advertisement
Table of Contents
