Clear Zone - Doss WDA-KIT ALARMFONE User Manual

Clear Zone

This option allows you to clear or delete PIR Sensors or Door Gap Sensors
from a particular zone. It is necessary to do this if;
1. You want to reduce the number of PIR Sensors/Door Gap Sensors in a
specific zone.
2. If one of the sensors is faulty in a specific zone.
3. If a sensor has been damaged
4. If a zone is no longer required
5. If a zone is sending a false alarm
Press the "SETUP" button and enter your four digit password. Press the
"DOWN" button twice and the LCD will display CLEAR ZONE.
1 REGISTER NEW
2 PARTIAL
3 CLEAR ZONE
4 BASE NO.
5 DEL BASE NO.
6 DELAY TIME
7 SIREN TIME
8 STATUS TO BASE
9 CHANGE PSW
10 PIR LOW POWER
Step 1:
Press the "#" key to select the option.
12:30
Mon
CL EA R Z ONE
Step 2:
The LCD screen will display ZONE 0. To change the zone press the "UP/
DOWN" buttons. To select the desired zone press the "#" key.
12:30
Mon
Z ONE 0
Note: ZONE 0 is allocated to your Remote Controls and cannot be cleared.
10 04
06
PM DISARM
10 04
06
PM DISARM
44