Table of Contents
Advertisement
Sel f Monitoring
The self monitoring function works in the same way as Back to Base
Monitor-ing except that the Doss Alarmfone sends the alert directly to
you via the telephone line. When the alarm is triggered the security
system sends the alert to the mobile or landline numbers you have
programmed into the Main Unit. When you receive the call from your
security system you will hear an alarm sound indicating the cause of
the alert.
Note: You will not know which zone is affected. Only a Monitoring Station has
the necessary set up to provide this information.
No. of Beeps
1 beep
2 beeps
3 beeps
4 beeps
8 beeps
1 long beep
2 long beeps
Step 1:
When you receive a phone call from your alarm system you will hear a siren
sound; the siren will play for 5 seconds and then it will switch off for 5 seconds
(on your phone, but not on the Alarmfone at your premises) while the system
is waiting for your response. If you don't press a button within 5 seconds the
siren will come on again for 5 seconds repeating the process.
Press "1" to stop the siren and listen into the room and hear intruder(s).
Press "4" and you will hear the beeps determining the alarm type as shown
above. (E.g., if you hear 3 beeps it means a forced entry alarm alert triggered
by a Door Gap Sensor; see the above table).
Step 2:
Press "2" to arm the system and you will hear a single beep.
Press "3" to disarm the system and you will hear two beeps.
Alarm Type
Tamper (PIR)
Intruder (PIR)
Forced entry (Door Gap)
Panic
Medical emergency
Gas
Smoke
51
REGISTERING NEW DEVICES
Additional devices need to be registered (or logged in "login") with the Main
Unit. Unless a new device is correctly registered it will not operate as part of
the security system. This section covers how to register new PIR's, Door Gap
Sensors, Remote Controls, Medical Alert Pendants, Gas Detectors and Smoke
Detectors.
New PIR
Press the "SETUP" button and enter your four digit password. Press the
"DOWN" button until the LCD screen displays REGISTER NEW.
Mon
12:30
REGI STER N EW
Step 1:
Press the "#" key to select the option.
1
LOGIN PIR
2
LOGIN DOOR
3
LOGIN REMOTE
4
LGN EMERGENCY
5
LOGIN GAS
6
LOGIN SMOKE
Step 2:
The LCD screen will display LOGIN PIR. Press the "#" key to select the option
12:30
Mon
LOG IN P IR
Step 3:
The LCD screen will display ZONE 1. Press the "UP/DOWN" buttons to select
the correct ZONE. ZONE selection must be from 1 to .
12:30
Mon
Z ONE 1
10 04
06
PM
DISARM
10 04
06
PM
DISARM
5
10 04
06
PM
DISARM
52
Advertisement
Table of Contents
