Table of Contents
Advertisement
Step 8:
The LCD will display PLS INPUT CID. Enter the four digit account number
supplied by your Monitoring Station and press the "SAVE" button.
12:30
Mon
134_
PL S I NPUT CI D
Step 9:
Press "*" key to exit the menu.
REGISTER NEW
PARTIAL
CLEAR ZONE
BASE NO.
DEL BASE NO.
DELAY TIME
SIREN TIME
STATUS TO BASE
STEP 1
CHANGE PSW
MONITOR STATIO
SELF MONITOR
PIR LOW POWER
10 04
06
PM
DISARM
STEP 2
STEP 3
STATION 1
PLS INPUT NO .
STATION 2
PLS INPUT NO .
ACCOUNT
PLS INPUT CID
Press*key to exit
30
Self Monitoring Numbers
This option is used when you choose not to have your alarm monitored
by a security monitoring service. In this case your Doss Alarmfone
will call either your mobile or another nominated number to alert you.
You can enter a minimum of one number and a maximum of nine
numbers with the self monitoring option.
Note: If you choose this option you must delete the pre-programmed base
numbers in the "MONITOR STATION" menu. See the section "Deleting
Base Numbers". Follow the steps immediately below (which are then
followed by the "Deleting Base Numbers" section).
Press the "SETUP" button and enter your four digit password. Press the
"DOWN" button three times until BASE NO. is displayed on the LCD screen.
1 REGISTER NEW
2 PARTIAL
3 CLEAR ZONE
4 BASE NO.
5 DEL BASE NO.
6 DELAY TIME
7 SIREN TIME
8 STATUS TO BASE
9 CHANGE PSW
10 PIR LOW POWER
Step 1:
Press the "#" key to select this option.
Mon
12:30
BA SE NO .
Step 2:
The LCD screen will display MONITOR STATIO. Press the "DOWN" button to
select SELF MONITOR option. To select press "#" key.
12:30
Mon
SE L F M ONI TOR
10 04
06
PM
DISARM
10 04
06
DISARM
PM
31
Advertisement
Table of Contents
