Table of Contents
Advertisement
TOP VIEW
0
Feet
PIR
SIDE VIEW
PIR
¡
14
0
4.8
9.7
14.5
19.3
24.9
29.1
After installing the PIR, open and close the PIR battery compartment. The PIR
will now be in "walk mode" for the next three minutes. The PIR LED will flash
on each movement.
(In normal mode the LED will only flash every three minutes to save battery
power).
Once the PIR is in "walk mode" you can walk in front of the PIR from one side
of the room to the other to determine the coverage area.
35
Feet
20
10
0
10
20
Feet
¡
7.5
Feet
~80
4
0
34
Feet
18
Note: It is recommended that you read carefully the last section "Zones" and
draw a rough floor plan of your property marking all
intended protected
zones and the location of each sensor
before installing you Doss
Avoiding False Alarms
¡
Do not install PIR in a location where there is known to be movement.
¡ Do not install PIR aiming at the window.
¡ Do not install PIR aiming at heating units.
¡ Do not install PIR near the heating vent, air-conditioning, fire place or
sunlight.
¡ Install the PIR in a permanent position. Do not place it on a shelf.
¡ Install the PIR within 30 metres of the Main Unit even though the PIR
sensor range is 100 metres in an open area.
¡ Pet movement will also trigger the PIR Sensor so consider other methods
of detection to areas where pets/animals have no access during times
when the alarm system is armed. (e.g., use additional Door Gap Sensors
on doors and windows to secure areas where there is likely to be movem-
ent when the system is armed).
Replacing PIR Batteries
Please ring the event monitoring Control Room whenever you are changing
PIR batteries, as an event signal ("TAMPER") will be sent to the Control Room
-a false alarm- which you do not want the Control Room to act upon.
Changing Your Password
You must change the default password when you set up your alarm system
for the first time.
"See Alarm Settings - Change Password"
Alarmfone.
19
Advertisement
Table of Contents
