Speco O2D10 Owner's Manual page 23

Motion Detection
Preview
You can preview the motion detection window on the preview
window.
General
> Sensitivity: Enter the sensitivity to detect an object in
motion.
• Save: Click this button to confirm the settings.
How to set the motion detect window
1. Click the [Add] button. The motion detect window is
displayed. You can add the three windows maximum for
motion detection area.
2. Set the [Sensitivity] option.
3. Click the edge or corner of the window box to adjust the
window size for motion detection.
4. Click the [Save] button to save the settings.
Note:
• The same sensitivity will be applied to all created motion
detection windows.
• Increase the sensitivity in the environment with a low lighting
condition or a few motion. On the contrary, in an environment
with a bright lighting condition or a lot of motion, decrease the
sensitivity.
• The Motion Detection function may not work depending on
your installation environment.
• Motion Detection settings area is not maintained by the screen
change by the operation of Pan / Tilt / Zoom. When resetting
the Pan / Tilt / Zoom, you need to reset the Motion Detection
settings also.
• You can reset the window size. Click one of the window edge or
corner and drag & drop to reset the motion detection area.
• Motion Detection can be activated when at least one of
channels is enabled, Video codec is set to H.264 and GOP size is
more than 2.
Operation and settings
Audio detection
Audio Detection
> Enable: Set to [ON] or [OFF]. The Basic Configuration menu is
displayed when set to [ON].
Basic Configuration
> Level: Select the level of audio detection from the
drop-down list. You can set the level using by jog control.
If you use jog control, the [Level] option is set to [Manual]
automatically.
> Input Graph: Displays at intervals 0.5 seconds within 25
seconds cumulative graph.
> Audio Detect Status: Displays the audio is detected or not.
• Save: Click this button to confirm the settings.
Smart Analytics
Preview
You can preview the camera image on the preview window.
Basic Configuration
> Tamper Detection: Detect changes on the screen and
operate in accordance with the registered Event.
- Enable: Set to [On] or [Off ].
> Face Detection: Detect a recognized face on the screen and
operate in accordance with the registered Event.
- Enable: Set to [On] or [Off ].
- Sensitivity: Set the [Sensitivity] option.
Additional Analytics (Available up to three)
> To set the detection area
1. Set to [ON] the desired algorithm.
2. Click the [Set Zone] or [Set Line] button.
23