Speco O2D10 Owner's Manual page 20

SNMP
The Simple Network Management Protocol (SNMP) is an application
protocol to exchange the management information of network
devices.
SNMP v1/v2c
> Enable SNMP v1/v2c: Selects when SNMP is allowed access
to this device.
> Read Community: Specifies the SNMP management
community in which you want to read this system.
> Write Community: Specifies the SNMP management
community in which you want to write this system.
SNMP v3
> Enable SNMP v3: Selects when SNMP v3 is allowed access to
this device. It supports authentication and encryption.
> SecurityName: Type the security name for the SNMP.
> Password: Type the password for the SNMP.
• Save: Click this button to confirm the settings.
20
QoS
You can specify network Quality of Service (QoS) settings.
QoS DSCP Configuration
> Video DSCP: Enter the priority of Video for DSCP
(Differentiated Service Code Point) Quality of Service.
> Audio DSCP: Enter the priority of Audio for DSCP Quality of
Service.
> Event DSCP: Enter the priority of Event for DSCP Quality of
Service.
• Save: Click this button to confirm the settings.
802.1x
Specifies whether 802.1x network access is enabled.
802.1x/EAPOL using EAP-TLS
> Enable: Select on to enable the protocol.
Certificates
> To upload or remove the certificates
1. Click the [Browse] Button.
2. Find and open the certificates file.
- CA Certificate: Upload the accredited certificate included
public key.
- Client Certificate: Upload the accredited certificate
included client authentication key.
- Client private key: Upload the accredited certificate
included client private key.
3. Click the [Upload] button to install certificates.
4. Click the [Remove] button to delete certificates.
Basic Configuration
> EAPOL Version: Select the EAPOL version.
> EAP ID: Enter the ID of the client certificate using up to 16
characters.
> Password: Enter the password of the client private key using
up to 16 characters.
• Save: Click this button to confirm the settings.
Operation and settings