Speco O2D10 Owner's Manual page 17

constant bit rate.
> Smart Codec: You can improve the image of a specific area
to configure the Region or Face Detection. If you select
the [Region] option, the [Smart Codec (Region)] window is
activated.
Note :
• When the video codec is H.264 or H.264_HIGH, the
Smart Codec can be selected.
• Two areas can overlap and the sum of the two areas
have to be less than 30 % of the total area.
• Smart Codec settings area is not maintained by the
screen change by the operation of Pan / Tilt / Zoom.
When reset the Pan / Tilt / Zoom, you need to reset the
Smart Codec settings area also.
> Stream quality: If the [Bitrate Mode] option set to VBR, this
option is displayed. Select the stream quality from the drop
down box, the camera supports five types. (Highest, High,
Medium, Low and Lowest)
> Video rate: If the [Bitrate Mode] option set to CBR, this
option is displayed. If the Profile is set to [Profile1], can be
set the Bitrate value from 1024 kbps to 10240 kbps. In case
of [Profile2], [Profile3], [Profile4], it can be set from 256 kbps
to 10 240 kbps.
Note:
If the 'Bit rate' is configured too low with high resolution,
the actual frame rate will decrease because of narrow
bandwidth. So you need to set or change the 'Bit rate' to a
higher value.
JPEG Snapshot Quality
> Snapshot Quality: Select the quality of JPEG snapshot.
• Save: Click this button to confirm the settings.
Operation and settings
Audio Setup
Audio In
> Enable: Click the check box if you want to send the audio
from the microphone input connector.
Note:
The Clients connected to the IP device remain unaffected
with additional changes made in the setting.
> Input: Select the type of audio input. (Line in, Microphone)
> Codec: Select the type of audio encoding.
(G711 PCMA, G711 PCMU, G726 24K, G726 32K)
Audio Out
> Enable: Click the check box to output the audio from the
speaker.
Note:
Depending on the camera and Network condition, it may
delay for a few seconds.
• Save: Click this button to confirm the settings.
17