System Information; Clear The Memory To Factory Default - PACH & COMPANY AeGIS 7000 Series Installation And Programming Manual

FUNCTION CODE
Step 4 Press
Step 5 Press
Step 6 Proceed to step 2 and select the same Function
Step 1 Log on to programming mode (see section 3.1),
46
SYSTEM
INFORMATION
Step 2 Enter Function Code 46 then press #, the
Display the model number
and the firmware released
date.
Step3
Step 1 Log on to programming mode (see section 3.1),
50
CLEAR THE
MEMORY TO
FACTORY
Step 2 Enter Function Code 50 then press #, the
DEFAULT
Use this Function Code will
erase the whole database
and and reset the system
to factory default. Step 3 Press 1 to confirm the display shows:
Step4
Pach and Company
AeGIS 7000 Series
LOCAL PROGRAMMING
to erase the 2 nd segment then enter
*
the welcome message then press # # to proceed
to the 3 rd segment, the display shows:
to erase the 3 rd segment then enter
*
the welcome message then press # #.
Code or different Function Code to continue
programming or press to exit the programming
*
mode and you will hear "Three Short Beeps".
Note: See keypad correlation on page 3.
the display shows:
display shows:
XXX: the model number.
MM/DD/YY: month, date, and year firmware
released.
Press then proceed to step 2 and select the
*
same Function Code or different Function Code
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
the display shows:
display shows:
and the system returns to Welcome Screen,
or to cancel and proceed to step 3.
*
Press then proceed to step 2 and select the
*
same Function Code or different Function Code
PROGRAMMING
to exit the
*
Chapter 3
TOUCH TONE PROGRAMMING
NOT AVAILABLE.
NOT AVAILABLE.
Page 14
09/01/01