Select Tone Or Pulse Dialing; Enable Or Disable Auto Answer; Turn On Or Off Key Press Beep - PACH & COMPANY AeGIS 7000 Series Installation And Programming Manual

FUNCTION CODE
same Function Code or different Function Code
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
73
Step 1 Log on to programming mode (see section 3.1),
SELECT TONE OR
PULSE DIALING
(Default setting is
tone)
Step 2 Enter Function Code 73 then press #, the
If set to Tone: pulse phone
can't unlock the door by
pressing 9.
If set to pulse: both tone
Step 3 Enter 1 for Tone or 0 for Pulse then press #.
and pulse phone can
unlock the door by
pressing 9.
Step4
74
Step 1 Log on to programming mode (see section 3.1),
ENABLE OR
DISABLE AUTO
ANSWER
(Default setting is
Step 2 Enter Function Code 74 then press #, the
Enable)
If Enable, the system will
answer an incoming call.
If disable, the system will
Step 3 Enter 1 to Enable or 0 to Disable, then press #.
not answer an incoming
call.
Step4
This feature is useful if:
• Remote touch-tone
programming is used or
• For the tenant to call
the system in case the
tenant is not available at
the time the visitor call.
75
Step 1 Log on to programming mode (see section 3.1),
TURN ON OR OFF
KEY PRESS BEEP
(Default setting is
ON)
Step 2 Enter Function Code 75 then press #, the
If ON, the system beep if
key is pressed.
If OFF, the system does
not beep if the key is
pressed.
Step 3 Enter 1 to turn ON key press beep or 0
If the system is set for
Multi (see Function Code
07),
Pach and Company
AeGIS 7000 Series
LOCAL PROGRAMMING
*
the display shows:
display shows:
Press then proceed to step 2 and select the
*
same Function Code or different Function Code
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
the display shows:
display shows:
Press then proceed to step 2 and select the
*
same Function Code or different Function Code
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
the display shows:
display shows:
turn OFF key press beep, then press #.
PROGRAMMING
to exit the
Step 1 Log on to programming mode,
Step 2 Enter Function Code 73 then
Step 3 Enter 1 for Tone or 0 for Pulse
Step 4 Select another Function Code
to exit the
*
to exit the
*
Step 1 Log on to programming mode,
Step 2 Enter Function Code 75 then
Step 3 Enter 1 to turn ON key press
press
Short
Chapter 3
TOUCH TONE PROGRAMMING
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear "Three Short
Beeps".
see section 3.2 If you have
logged on proceed to step 2.
press #, you hear "One Short
Beep".
then press #, then press # and
you will hear " Two Short
Beeps".
to program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear "Three Short
Beeps".
NOT AVAILABLE.
see section 3.2 If you have
logged on proceed to step 2.
press #, you hear "One Short
Beep".
beep or 0 to turn OFF key press
beep then press #, then
#and you will hear "Two
Beeps".
Page 16
09/01/01