Change Talk Time; Change Door Open Interval; Change Lock Out Count - PACH & COMPANY AeGIS 7000 Series Installation And Programming Manual

FUNCTION CODE
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
Step 1 Log on to programming mode (see section 3.1),
70
CHANGE TALK
TIME
(Default setting is
Step 2 Enter Function Code 70 then press #, the
60
seconds)
The talk time is the length
of time the visitor can talk Step 3 Enter Talk Time Value in 3-digit mode (010 -
to the tenant. The talk time
timer starts as soon as the
system initiates the call.
Step4
71
Step 1 Log on to programming mode (see section 3.1),
CHANGE DOOR
OPEN INTERVAL
(Default setting is
12 seconds)
Step 2 Enter Function Code 71 then press #, the
The Door Open Interval is
the length of time the
relay turns on.
Step 3 Enter the Open Time value in 2-digit mode (04-
Step4
Step 1 Log on to programming mode (see section 3.1),
72
CHANGE LOCK
OUT COUNT
(Default setting is
Step 2 Enter Function Code 72 then press #, the
3)
The system is disabled if
invalid access code has
been entered according to
the lock out count sets on
Function Code 72. The
Step 3 Enter the lock out count in one-digit mode (1-9).
system will ignore further
access code entries for 90
seconds. Step4
Pach and Company
AeGIS 7000 Series
LOCAL PROGRAMMING
*
the display shows:
display shows:
180) seconds the press #.
Press then proceed to step 2 and select the
*
same Function Code or different Function Code
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
the display shows:
display shows:
99) seconds then press #.
Press then proceed to step 2 and select the
*
same Function Code or different Function Code
to continue programming or press
programming mode and you will hear "Three
Short Beeps".
the display shows:
display shows:
Press then proceed to step 2 and select the
*
PROGRAMMING
to exit the
Step 1 Log on to programming mode,
Step 2 Enter Function Code 70 then
Step 3 Enter the talk time in 3-digit mode
Step 4 Select another Function Code to
to exit the
*
Step 1 Log on to programming mode,
Step 2 Enter Function Code 71 then
Step 3 Enter the Open Time value in 2-
Step 4 Select another Function Code to
to exit the
*
Step 1 Log on to programming mode,
Step 2 Enter Function Code 72 then
Step 3 Enter the Lock Out Count value in
Step 4 Select another Function Code to
Chapter 3
TOUCH TONE PROGRAMMING
see section 3.2 If you have
logged on proceed to step 2.
press #, you hear "One Short
Beep".
(10-180 seconds) and press #
and you will hear " Two Short
Beeps".
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear "Three Short
Beeps".
see section 3.2 If you have
logged on proceed to step 2.
press #, you hear "One Short
Beep".
digit mode (04-99) seconds then
press # and you will hear " Two
Short Beeps".
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear "Three Short
Beeps".
see section 3.2 If you have
logged on proceed to step 2.
press #, you hear "One Short
Beep".
one-digit (04-99) seconds then
press # and you will hear " Two
Short Beeps".
Page 15
09/01/01