FUNCTION CODE
46
DISPLAY SYSTEM INFORMATION
50
CLEAR THE EEPROM MEMORY
TO FACTORY DEFAULT
78
VIEW DIRECTORY AND NAME
Pach and Company
AeGIS NPB9000P Series
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 46 then press # and the display shows
XXXX= a maximum number of tenants
YYYY= a maximum number of keypad access code and card.
MM.DD.YYYY= Month. Date. Year the Firmware is released.
Then the display shows
Step 3 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 50 then press # and the display shows
Step 3 Enter 1=TO CLEAR or 0=TO CANCEL then press #, the display shows
Step 4 Wait for a few minutes, the more tenants programmed the longer it takes to
erase the memory the the display shows
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 78 then press # and the display shows
Chapter 3
PROGRAMMING
LOCAL PROGRAMMING
NNNNNNNNNNN= tenant name
Page 29
06/20/11