Radio - PEUGEOT Coupe 406 Handbook

Radio
Selecting a station
Automatic search
Briefly press button <4 (17) or ~ (19) to
search for the frequency of the station imme-
diately above or below the frequency cur-
rently being displayed.
The search is indicated by the rapid and con-
tinuous changing of the frequency displayed.
Following the search, the display will indicate
the frequency of the station to which the radio
is tuned.
In TA mode, the search is limited to RDS
stations which transmit traffic information.
TA mode is one of the functions offered by
the RDS.
Automatic frequency search can also be
carried out using the remote control.
Rapid manual search
Press and hold button <4 (17) or ~ (19) in
order to rapidly scan stations on a lower or
higher frequency.
Releasing the button will stop the search. The
frequency of the station obtained at the end
of the scan is then displayed.
Manual search in stages
Briefly press button <4 (17) or ~ (19) to seek
stations one by one on a higher or lower
frequency.
Remarks
If, after scanning the whole waveband, no
transmitting station is located, the system
changes to "distance" mode, in order to seek
transmitting stations with a weaker signal.
Storing stations in the memory
The radio can store thirty stations using the
six memory buttons (1) to (6):
- six stations on FM1 waveband
- six stations on FM2 waveband
- six stations on AST waveband
- six stations on MW
- six stations on LW
The six frequencies in the AST range are
automatically stored in the memory
(Autostore function). Storing a frequency on
any other waveband is done manually.
Manually storing
a
station in the memory
Select the waveband required, with the
exception of AST (see "Selecting a wave-
band").
Select the station required (see "Selecting a
station").
Press one of the pre-selection buttons (1) to
(6) for at least two seconds.
Wait for the bleep indicating that the station
has been stored.
The newly stored station replaces the station
previously stored on this pre-selection button
on this waveband.
131
Storing FM stations automatically
(Autostore function)
The Autostore function permits the six most
powerful FM stations to be searched for and
stored automatically.
This function is only available on FM. If an
attempt is made to store stations automa-
tically in MW or LW, the system will emit a
low-pitched bleep and "NO AST" will be
displayed.
Press button AST (16) for at least two
seconds.
The radio will bleep.
The display will show "FM AST".
The system will store the six strongest sta-
tions on AST.
When the six stations have been stored, the
system will bleep.
The radio will tune to the station stored on
AST pre-selection (1).
The newly stored stations replace the sta-
tions previously stored on AST.
If the system cannot find six stations, each
blank pre-selection is programmed "0000
AST" (this is displayed when the pre-selec-
tion button is pressed).