Battery - PEUGEOT Coupe 406 Handbook

100
BASIC ELECTRICAL MAINTENANCE: Battery
Removing the battery
Disconnect the battery, starting with the (-)
terminal.
Disconnecting the battery may lead to tem-
porary engine or equipment (window lift)
operation faults.
If the faults persist, consult your PEUGEOT
dealer.
Replacing the battery
Connect the battery, starting with the (+) ter-
minal.
Press the connectors down firmly, then
tighten the terminals by hand.
A continuous electrical supply is necessary
for the operation of the electronic systems.
Each time the battery is disconnected, switch
on the ignition and wait 10 seconds before
starting.
However, if slight disturbances persist follow-
ing this operation, consult your PEUGEOT
dealer.
Precautions
Check that the terminals and connectors are
clean. If they are covered with sulphate
deposits, disconnect and clean them. Never
disconnect the terminals when the engine is
running. Never charge the battery without
having disconnected both terminals. If the
battery allows it, from time to time check the
level of electrolyte which must always cover
the plates'. If necessary, top up with distilled
water. In case of acid overflow, apply a ribbon
of grease to the base of the battery terminal.
Recharging
The recharge voltage should never exceed
15.5 volts. Setting: 5 amperes maximum.
Recharge duration: 24 hours.
Always use a constant voltage charger.
-~.-----,----~-.~-------------~.-~-.--
If the vehicle is used intensively in
high temperatures (30°C and above)
You are advised to check the electrolyte level
which must always cover the plates. If nec-
essary top up with distilled water.
If the vehicle is not in service for a
long time
If the vehicle is not in service for more
than one month, disconnecting the battery
is recommended.
Jump-starting
If the battery is discharged, it is possible to
use a separate emergency battery or the
battery of another vehicle. To avoid risks of
explosion, carefully follow the sequence
indicated on the following page.
, According to specification