Table of Contents
Advertisement
SUPERSERVER 6017R-WRF/NTF USER'S MANUAL
Note: For your system to work properly, please follow the links below to download
all necessary drivers/utilities and the user's manual for your server.
•
Supermicro product manuals:
•
Product drivers and utilities:
•
Product safety information:
http://super-dev/about/policies/safety_information.cfm
•
If you have any questions, please contact our support team at:
support@supermicor.com
1-2
Serverboard Features
At the heart of the SuperServer 6017R-WRF/NTF lies the X9DRW-iF, a dual
processor serverboard based on the Intel PCH 602 chipset. Below are the main
features of the X9DRW-iF. (See Figure 1-1 for a block diagram of the chipset).
Processors
The X9DRW-iF supports single or dual E5-2600 Series processors in
Socket R LGA2011 type sockets. Please refer to our web site for a complete listing
of supported processors (www.supermicro.com).
Memory
The X9DRW-iF has sixteen (16) quad channel 240-pin DIMM sockets that can
support up to 512 GB of DDR3 1600/1333/1066/800 MHz speed registered
ECC RDIMM/LRDIMM SDRAM in two-channel memory bus. Memory sizes of
1GB, 2GB, 4GB, 8GB, 16GB and 32GB @ 1.35V/1.5V voltages are supported.
Please refer to Chapter 5 for installing memory.
Note: LRDIMM (Reduced Load) memory supports only 1333/1066/800 MHz speed
memory.
Serial ATA
An on-chip (Intel PCH 602) SATA controller is integrated into the X9DRW-iF to
provide a six-port SATA subsystem (two SATA 3.0 and four SATA 2.0 ports), which
is RAID 0, 1, 5 and 10 (Windows SATA) or RAID 0, 1 and 10 (LINUX) supported.
The SATA drives are hot-swappable units.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
http://www.supermicro.com/support/manuals/
ftp://ftp.supermicro.com
1-2
Advertisement
Table of Contents
