Control Panel Buttons; Reset; Power; Uid - Supero SUPERSERVER 6017R-WRF User Manual

SUPERSERVER 6017R-WRF/NTF USER'S MANUAL
3-2

Control Panel Buttons

There are three push-buttons located on the front of the chassis: a reset button, a
UID button and a power on/off button.

Reset

Use the reset button to reboot the system.

Power

This is the main power button, which is used to apply or turn off the main system
power. Turning off system power with this button removes the main power but keeps
standby power supplied to the system.

UID

Depressing the UID (unit identifi er) button illuminates an LED on both the front
and rear of the chassis for easy system location in large stack confi gurations. The
LED will remain on until the button is pushed a second time. Another UID button
on the rear of the chassis serves the same function. See the table in Figure 3-1 for
descriptions of UID LED states.
State
Fast Blinking Red (1x/sec)
Solid Red
Slow Blinking Red (1x/4 sec)
Solid Blue
Blinking Blue
Note: deactivating the UID LED must be performed in the same way it was activated.
(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and
not with the UID button.)
Universal Information LED States
Indication
Fan Fail
CPU Overheat
Power Fail
Local UID Button Depressed
IPMI-Activated UID
3-2