Change The Remote Control Id - Vitek VT-SRE Spire Elite User Manual

\ \

Change the remote control ID

The remote control will only function if the Remote Control iD matches with that specified on the DVR.
if multiple DVRs are installed at one location and you would like to have just a single remote control, use the iD button to
set the remote control iD. Only the iD-matching DVR can be controlled.
1.
From <MEnU> - <SySTEM SETUP> - <SySTEM> - <COnTROL DEViCE> under the System Setup menu, set the
<REMOTE COnTROLLER iD> and press <APPLy>.
Select between 00 and 99. For more details, refer to <SySTEM SETUP>.
2.
Press the [iD] button on the remote control. The default remote control iD is 00.
3.
Use the number buttons to provide a two-digit iD. if you want to enter 01, for instance, enter the number 0 and 1 in
sequence.
To check if the remote control iD is set properly, manipulate the remote control and see if the DVR responds.
4.
To reset the iD to 00, press and hold the [iD] button.
7