Operation M Ode - OM POWER OM2000+ Manual

5.3. Operation m ode
In STBY the amplifier is in bypass-mode and your transceiver is directly connected to
the antenna. Maximum allowed power in bypass mode is 200 Watts! Passing RF power
is measured with analog wattmeter only. It is not displayed if PA is either in standby
mode or turned OFF.
CAUTION
Use UP or DOWN to select Calibration Ip &
Is. P ress E NT t o d o i t.
Ip a nd I s c alibration r uns i n t he b ackground.
Result o nly i s v isible o n t he d isplay.
Press E SC t o g o o ne l evel b ack.
Press OPER to activate operation mode.
STBY L ED s witched O FF.
Changing o f D SP a llows u ser t o w atch c ouple
of basic parameters of the PA in operation
mode without input RF signal. Notice: These
are three default display settings (software
version 6 .1.)
21