Lewmar AutoAnchor 550 Operation Manual page 7

After selecting feet or metres, enter calibration mode as
follows:
Turn the AA550 off.
Step 1
Step 2 Hold down the MODE button and press and release the
ON/OFF button. Release the MODE button. The AA550 will flash
between Item 1 and the current setting. (Refer below).
Item Setting
The safety lock should be left ON at all times. If you choose to
disable the safety lock use the UP or DOWN button to change the
display setting to OFF. To set the safety lock again press the UP or
DOWN button to reset to ON. Press the MODE button to advance
to the next item. The display will flash between Item 2 and the cur-
rent setting for Item 2.
Item Setting
This sets the length of rode to be retrieved by manual operation of
the unit after the automatic upward control has stopped. For safety
the anchor retrieval stopping point cannot be set below 2 ft (0.7 m).
Use the UP or DOWN buttons to enter the value in feet or me-
tres. The setting is accurate to +1 chainwheel revolution. Press the
MODE button to advance to the next item. The display will flash
between Item 3 and the current setting for Item 3.
Item Setting
Use the UP or DOWN buttons to enter the total length of the rode.
The minimum setting is 32 ft (10m). Press the MODE button to
advance to the next item. The display will flash between Item 4 and
the current setting for Item 4.
Item1: Safety Lock
Default Setting is ON
Record Calibration Entered: ___________________
Item 2: Anchor retrieval Stopping Point
Default Setting 4 ft or 1.5 m
Record Calibration Entered: ___________________
Item 3: Total Length of rode on Board
Default Setting 196 ft or 60 m
Record Calibration Entered: ________________
4