Table of Contents
Advertisement
A
Enable Automatic Operation: The AA550 is supplied with the
length of rode to be released set to OFF. The automatic function
cannot be used until a "rode to be released" value is entered. (See
Step 3 below). Once a "rode to be released" value has been entered
the AA550 remains enabled for automatic operation. The setting
is retained by the AA550 even if the battery fails. To disable the
automatic operation use the DOWN button to reset the "rode to
be released" to OFF.
To release the Anchor and rode
Step 1
Turn the AA550 on.
Clear the safety lock if necessary. (Refer to page 8).
Step 2
Press the MODE button once. The value flashing shows
Step 3
AUTO and the preset length of rode to be released. If this value is cor-
rect go to Step 4 below.
To change the rode to be released setting: Press MODE again. The
display will flash between SET and the current value. (The default
setting is OFF). Use the UP or DOWN buttons to change the setting.
Press the MODE button again to return to AUTO and go to Step 4 be-
low to release the anchor. Or press the MODE button twice to return
to normal operation. If you do not change the SET value, press the
MODE button once to return to normal operation.
Press and release the DOWN button. The windlass will
Step 4
deploy the anchor and rode. The windlass will stop and the AA550
will beep when the preset length of rode has been fully released.
UT0MATIC
A
NCHOrING
10
Hide quick links:
Advertisement
Table of Contents
