Oki OKIOFFICE 1200 Field Engineering Manual page 55

Memory Switch E:0 - Scanner
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Factory use only
1 0 Factory use only
0 1 Document TX length limit
0: 3.6 meters
1: 1 meter
Memory Switch E:1 ∼ ∼ ∼ ∼ F:9 --- Factory use only
Memory Switch G:0 - Remote reception
Initial
Switch
Setting
7 0 Factory use only
6 1 CML relay off time after
dialing
0: 1 sec
1: 200 ms
5 0 DTMF tones heard through
handset
0: No
1: Yes
4 0 Factory use only
3 0 Factory use only
2 0 Switch to fax upon TAD
disconnect
0: No
1: Yes
1 0 Factory use only
0 0 Remote reception from fax
handset
0: No
1: Yes
Adjust
Setting to unlimited will override document jam
sensing.
Adjust
When dialing from the keypad, phone line noise
may occur as the CML relay switches on and off.
Set this switch to "0" to avoid this.
Determines if DTMF tones are produced through
the handset in off-hook dialing.
In Ans/Fax Ready mode, if this switch is set to "1",
the unit will switch to fax when any device
connected to the external telephone jack, such as a
second phone or TAD, hangs up.
Ability to perform remote reception (hook-flash
transfer) from the fax handset.
3-28
Usage/Comments
Usage/Comments