Oki OKIOFFICE 1200 Field Engineering Manual page 121

What you see on the LCD
Drum Near End
Enter No. (0-32)
Enter No. (000-255)
Enter Reduce/Enlarge
Enter Scan Size
Feeder In Use
Hang Up Phone
In Relay Box
In Secure Box
In Use in P OneTouch
Invalid I.D. Code
Invalid Number
Invalid Paper Size
Invalid Passcode
Line Busy
Macro In Use
Memory Overflow
Start Or Cancel
What it means/What to do
Your drum will need to be replaced soon.
You tried to enter a call group number greater than 32. Your machine can
maintain 32 call groups, numbered 1-32 (call group 0 covers all the
groups).
Determine the correct call group identifier number and enter it, instead.
If the optional NIC (network interface card) is attached to your machine,
and you tried to enter a TCP/IP address greater than 255.
Enter the correct TCP/IP address.
You tried to copy your document on the paper other than A4, A5 or F4
sized paper using the bypass tray, or the calculated reduction or
enlargement ratio is out of the acceptable range (50 – 200 %) when the
copy reduction or enlargement ratio is set to "Auto".
Enter the reduction or enlargement ratio manually although a part of the
image might be lacked, or change the paper for copying.
When you using the FBS (Flatbed scanner) glass, you must manually
enter the scan size of your document.
Press DOCUMENT SIZE to choose the size.
The command you're trying to enter requires the use of the ADF, which is
already in use.
Wait for the machine to stop using the ADF, then try again.
The optional handset is off-hook.
Hang it up, making sure the upper part of the handset presses down on
the "hook" button.
You tried to store a document for polling in an F-Code box which is set to
be a relay box.
Select an F-Code box which is set to be a bulletin box, then try again.
You tried to store a document for polling in an F-Code box which is set to
be a security box.
Select an F-Code box which is set to be a bulletin box, then try again.
You tried to erase the F-Code box or Batch box, which is programmed in
the programmable one-touch key.
Erase the programmable one-touch key that contains the F-Code box or
Batch box you want to erase, then try again.
The F-Code box I.D. code you entered isn't valid.
Try re-entering your F-Code box I.D. code.
You pressed a key which has no function during the current operation.
If the optional printer controller is attached to your machine, it can use the
special sized paper with the bypass tray. However, it should be used only
for the PC printing, it cannot be used for copying. So, if you tried to copy
onto the special sized paper with bypass tray, this message will appear.
The protection passcode you entered isn't valid.
Repeat the operation, entering the correct protection passcode.
You tried to erase a document which someone is polling from your
machine.
Wait for the fax to complete the polling operation, then try again.
You tried to change the function for a Soft key, but that Soft key has been
programmed in a Macro key. You cannot change the Soft key function
until erase the Macro key that contains the Soft key you want to change.
Erase the Macro key, then try again.
During transmission (or copying), you tried to enter more pages into
memory than your fax could store.
Press START to tell your fax to keep as many pages in memory as
possible, or press CANCEL to delete from memory all pages stored
during this operation (but not previous operations).
4-14