Oki OKIOFFICE 1200 Field Engineering Manual page 46

Memory Switch A:0 - Dialer
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 DIS detect time after dialing
0: 80 sec
1: 70 sec
2 1 Factory use only
1 1 Dial tone detection
0: Do not dial
1: Dial
0 0 Phone line type
0: PSTN
1: PBX
Memory Switch A:1 - Dialer
Initial
Switch
Setting
7 0 Dial pulse
0: Not available
1: Available
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 PBX mode dial pause
2 0
1 1
0 1
Memory Switch A:2∼ ∼ ∼ ∼ A:4 --- Factory use only
Adjust
Sets the time DIS signal is detected after dialing a
number.
Determines if the unit proceeds with dialing or
indicates an error if no dial tone is detected within
five seconds of going off-hook.
When set to PSTN, the unit checks for dial tone and
acts according to the setting of memory switch A:0,
bit 1. When set to PBX, the unit always dials a given
number of seconds after going off-hook. Memory
switch A:1 sets the number of seconds.
Adjust
When set to "1", the dial pulse setting can be
selected in the phone type setting in EasyStart.
Sets the number of seconds the unit waits before
dialing when memory switch A:0, bit 0 is set to PBX
mode.
Switch 3 2 1 0
3-19
Usage/Comments
Usage/Comments
Pause time
0 0 0 0 0 sec
0 0 0 1 1 sec
0 0 1 0 2 sec
0 0 1 1 3 sec Initial setting
0 1 0 0 4 sec
0 1 0 1 5 sec
0 1 1 0 6 sec
0 1 1 1 7 sec
1 0 0 0 8 sec
1 0 0 1 9 sec
1 0 1 0 10 sec
1 0 1 1 11 sec
1 1 0 0 12 sec
1 1 0 1 13 sec
1 1 1 0 14 sec
1 1 1 1 15 sec