Installer Menu Options; Amplifier Status Screen - Elan D16 Installation Manual

E L A N H O M E S Y S T E M S
Figure 2-5
Amplifier Status
© ELAN Home Systems 2010 | All rights reserved.

Installer Menu Options

The D16 has two operating modes, Normal and ELAN.
(See Operating Mode Menu on page 23.)
ELAN mode allows the amplifier to respond to D16 IR and VIA!NET commands that
can affect its channels. (See Appendix A for the Command Set.)
NORMAL mode does not allow IR or VIA!NET control of the D16.
To access the installer menu screens press and hold the MENU button for five seconds
until the following screen shows in the display window. To exit the installer menu screens
press and hold the MENU button again for five seconds or power cycle the amplifier.

Amplifier Status Screen

D16 AMPLIFIER STATUS
NORM MODE:CH1->CH16
CH:1 V:75
CH:2 V:75
CH:3 V:85
CH:4 V:85
Press Up/Dn For More
The Amplifier Status screen allows you to view the current assignments for amplifier gain
and input routing for each of the 16 channels. Press the UP and DOWN arrow buttons to
see information for the next group of four channels. Alternatively, press the CHANNEL
button to move forward one channel at a time.
The top of the screen displays the mode the amplifier is in, either ELAN MODE or NORMAL
MODE, followed by the channel designations of the chassis,
I.E. CH1 – CH16.
CH:1 V:75 IN:1 means that audio input 1 (IN:1) is being amplified at 75% (V:75) and is
being routed to the channel 1 (CH:1) amplified output.
IN:1
IN:2
IN:3
IN:4
D16
INSTALLATION MANUAL
Page 13