Configuring Encoding Parameters - Smartwatch H20SWDVR4R Operation Manual

SmartWatch DVR Operation Manual

5.1 Configuring Encoding Parameters

Purpose:
By configuring the encoding parameters you can define the transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota, please set the maximum record capacity and maximum picture capacity.
For detailed information, see Chapter 10.5 Configuring Quota Mode.
3) If the HDD mode is Group, you should set the HDD group. For detailed information, see Chapter
5.9 Configuring HDD Group for Recording.
Steps:
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
2. Set encoding parameters for main stream.
1) Select Record to enter the main stream settings interface.
Figure 5.1 HDD- General
Figure 5.2 HDD- Advanced
Figure 5.3 Encoding Parameters-Main Stream
48