Configuring Upnp - Smartwatch H20SWDVR4R Operation Manual

SmartWatch DVR Operation Manual
information via SNMP port. By setting the Trap Address, the device is allowed to send the alarm event and
exception message to the surveillance center.

9.2.5 Configuring UPnP™

Purpose:
UPnP™ permits the device to seamlessly discover the presence of other network devices on the network and
establish functional network services for data sharing, communications, etc. If you want to use the UPnP™
function to enable fast connection of the device to a WAN via a router, you should configure the UPnP™
parameters of the device.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router to
which your device is connected. When the network working mode of the device is set as multi-address, the
Default Route of the device should be in the same network segment as that of the LAN IP address of the router.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the UPnP™ tab to enter the UPnP™ interface.
3. Check checkbox to enable UPnP™.
4. Set the mapping type to Auto or Manual.
When you select Auto, the mapping ports can be automatically assigned by the router. When you select
Manual, you should continue to Step 5 to edit the mapping ports.
5. Click to open the External Port Settings dialog box. Configure the external port No. for server port,
HTTP port and RTSP port respectively.

You can use the default port No., or change it according to actual requirements.

External Port indicates the port No. for port mapping in the router.
Figure 9.16 UPnP™ Settings Interface
125