SmartWatch DVR Operation Manual
4.1 Configuring PTZ Settings
Purpose:
Follow the procedure to set the parameters for PTZ. The configuring of the PTZ parameters should be carried
out before you control the PTZ camera.
Before you start:
Check that the PTZ and the device are connected properly through the RS-485 interface.
Steps:
1.
Enter the PTZ Settings interface.
Menu>Camera>PTZ>General
2.
Choose the PTZ camera for PTZ whose settings you want to adjust in the Camera dropdown list.
3.
Enter the parameters of the PTZ camera.
All the parameters should be exactly the same as the PTZ camera parameters. Only PTZ Protocol
can be set for network cameras.
Example: If the PTZ camera has a Baud rate as 115200, you should input 115200 in the Baud rate field.
4.
Click Copy if you want to use the same settings for other PTZ cameras.
5.
Click Apply to save the settings.
4.2 Setting PTZ Presets, Patrols & Patterns
Before you start:
Please make sure that the presets, patrols and patterns are supported by the PTZ protocols.
4.2.1 Customizing Presets
Purpose:
Follow these steps to set the Preset location which you want the PTZ camera to point to when an event takes
place.
Steps:
1.
Enter the PTZ Control interface.
Menu>Camera>PTZ>More Settings
Figure 4.1 PTZ- General
38