Wan Speed - iBall Baton iB-WRB300N User Manual

300M MIMO Wireless-N Router
(iB-WRB300N)
Some ISP may require binding an accepted MAC address for communication. If the bound MAC
address differs from your router's predefined WAN MAC address, then you need to replace the
router's WAN MAC with the bound MAC for achieving valid communication with your ISP.
● MAC Address: Configure router's WAN MAC address.
● MAC Address Clone: Clicking this button changes router's WAN MAC address from default to
the MAC address of the PC you are currently on. Don't use this button unless your PC's MAC
address is the one bound by your ISP.
● Restore Default MAC: Restores router's WAN MAC to default settings.

4.4 WAN Speed

This section allows you to configure WAN speed. Default settings are recommended.
● AUTO: DO NOT change this default setting unless you are connecting an excessively long
Ethernet cable from your ISP, which may degrade drive capability, to the router's WAN port.
● 10M HALF-duplex: Select it if your router's WAN port does not function properly when
connected to an Ethernet cable from your ISP; excessive length of the cable may degrade drive
capacity of the WAN port.
● 10M FULL -duplex: Select it to set router's WAN port to work at 10Mbps in full duplex mode,
improving WAN port drive capacity.
● 100M HALF-duplex: Select it to set router's WAN port to work at 100Mbps in half duplex
mode.
● 100M FULL-duplex: Select it to set router's WAN port to work at 100Mbps in full duplex
mode.
16