Mac Clone - iBall Baton iB-WRB300N User Manual

300M MIMO Wireless-N Router
(iB-WRB300N)
● MTU: Maximum Transmission Unit. DO NOT change factory default value unless necessary.
However you may need to change it for optimal performance with some specific websites or
application software that cannot be opened or enabled; in this case, try 1450, 1400, etc.
● Address mode: Select "Dynamic" if you don't get any IP information from the PPTP server,
otherwise select "Static".
● IP address: Enter the IP address information provided by your ISP (PPTP server). Inquire your
local ISP if you are not clear (Static IP address mode only).
● Subnet mask: Enter the subnet mask provided by your ISP, normally, 255.255.255.0 (Static IP
address mode only).
● Gateway: Enter the gateway provided by your ISP (Static IP address mode only). Inquire your
local ISP if you are not clear.
4.2.5 L2TP
● WAN Connection Type: Displays the current Internet connection type.
● L2TP Server address: Enter the IP address of a L2TP server.
● Username/Password: Enter Username/Password specified by the PPTP server.
● Address mode: Enter the IP address information provided by your ISP (PPTP server). Inquire
your local ISP if you are not clear (Static IP address mode only).
● IP address: Enter the IP address information provided by your ISP (PPTP server). Inquire your
local ISP if you are not clear (Static IP address mode only).
● Subnet mask: Enter the subnet mask provided by your ISP, normally, 255.255.255.0 (Static IP
address mode only).
● Gateway: Enter the gateway provided by your ISP (Static IP address mode only). Inquire your
local ISP if you are not clear.

4.3 MAC Clone

This section allows you to configure router's WAN MAC address.
15