How To Fit A Sata Drive To The Removable He-1 Enclosure - Datavideo HDR-70 Instruction Manual

HD / SD Recorder

How to fit a SATA drive to the removable HE-1 enclosure

Datavideo recommends using 2.5" SATA HDD 7200 RPM with 8 or 16 MB cache. If your unit was
delivered without a hard drive fitted please follow these instructions to fit your drive to an HE-1 drive
enclosure.
Compatible drive information can obtained from your local dealer or Datavideo office.
6. You are now ready to switch the unit on.
7. New drives will be formatted within the recorder upon first use. The LCD Clip Status
display is shown once the recorder becomes available for set up and use.
1. Remove the two small screws from the
connections end
enclosure, then remove the PCB.
2. Seat your 2.5" SATA HDD on to the PCB
and then turn it over so you can secure the
drive to the PCB using the four screws
holes provided.
3. Return the PCB, with HDD fitted, to the
enclosure, using the slots within the
enclosure case as a guide.
4. Re-secure the back plate of the enclosure
using the two screws removed earlier.
5. Push the removable HE-1 enclosure into
recorder as shown. Now move the locking
lever from right to left side in order to
secure the HE-1 in place.
7
HDR-70
of the HE-1 drive